List the materials needed for Activity 4.1 and describe how the circuit is set up. Why is the middle portion of the longer wire stretched between two nails, slightly above the surface of the cardboard?
Hint. Look at what has to fit underneath that stretched piece of wire.
Materials. A magnetic compass, an electric cell, a cell holder, two drawing pins, a safety pin, two nails, two pieces of connecting wire (one longer and one shorter), and two small pieces of cardboard.
Setting it up.
- Make a switch from the two drawing pins, the safety pin and a piece of cardboard — the same switch built in Electricity: Circuits and their Components, Curiosity Grade 7.
- Put the cell in the cell holder.
- Fix the two nails to the second piece of cardboard and stretch the middle part of the longer wire between them, so that it runs straight and clear of the cardboard (Fig. 4.1a).
- Join one end of that wire to the cell holder and the other end to the switch.
- Join the shorter wire between the cell holder and the switch, completing the circuit.
- Place the magnetic compass beneath the stretched wire, between the two nails.
✦ Why the wire is raised on nails. The compass has to sit directly under the wire and as close to it as possible, because the magnetic effect is strongest near the wire. Stretching the wire between two nails leaves a clear gap for the compass to be slipped underneath, and it also keeps that stretch of wire straight and fixed. That matters: if the wire were free to move it might be nudged by hand while you switch on, and you would not be able to tell whether the needle moved because of the current or because the wire shifted.
So the arrangement is doing two jobs at once — getting the detector close enough, and removing an obvious source of doubt about what caused the movement.
